FIND US ON FACEBOOK
YOU HAVE (0) ITEMS IN YOUR CART
> Hill Audio IPA200 Power Amplifier
Hill Audio IPA200 Power Amplifier
Move mouse over the image to magnify
2 Channel 80W at 4 Ohm or 50W at 8 Ohm Install amplifier
IPA200 Power Amp
The IPA200 is an ultra-versatile power amplifier for installation purposes. It can serve both as a stereo and as a dual-mono amplifier, and the inputs can even be configured to sum to stereo signals into two mono signals in case that a source is stereo but a mono zone needs to be fed. Input high-pass filters and 2-band EQs are available separately for each channel to cater for driving speakers with limited bass response like ceiling speakers. Rear-side maximum volume controls avoid that certain volumes can be exceeded, and the front-panel volumes controls can be completely disabled if needed. The IPA200 is the most versatile low-impedance installation amplifier available.
Linear power amplifier
Bipolar power devices
Two independent mono amplifier blocks with 80W@4Ohms / 50W@8Ohms RMS power each
Binding post speaker outputs
Stereo and parallel mono operation modes of the two mono blocks
Mono-summing option for two incoming stereo signals allowing to process two stereo signals into two mono signals and send them to one amplifier block each for mono zoning
2-Band-EQ, 40Hz and 80Hz HighPass filters for each amplifier block input
Balanced (XLR and Phoenix) and unbalanced (RCA) inputs
¼’’ TRS line-level outputs in parallel to inputs
Front-side volume control with 41-click precision potentiometers
Additional rear-side volume control for each block to limit the maximum volume
Front-side volume controls can be disabled by rear-side switch
2x10LED front-side level meter
Noiseless convection cooling
Linear power supply with toroidal transformer
Power, stereo: 2×50/80 @ 8/4 Ohms
Frequency response: 20Hz-20kHz +/- 1dB
THD < 0.05%
Damping factor > 300
Dimensions: 483×44.5x194mm WxHxD
EU safety: EN 60065:2001 +A1
EU EMC: EN55103-1:1997, EN55103-2: 1997
US safety: UL60065
US EMC: FCC Part 15
This product meets both the EMC Directive 2004/108/EC and the Low Voltage Directive 2006/95/EC.
This product is manufactured in accordance with EG directive 2002/95/EG of the European Union on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS).
This product does not contain more than 0.1% of weight of the SVHCs listed in annex XIV of the REACH regulation EC 1907/2006.
You might also be interested in ...
DW Double Section Wall Mount Rack Enclosure
Hill Audio RPL1000
Hill Audio SMA1220 12" Active Speaker
GET IN TOUCH
P: + 64 9 378 9863
F: + 64 9 378 0542
Find us on Facebook
34C Crummer Road, Grey Lynn 1021,
Auckland, New Zealand
8:30-5 Monday to Friday.